How to order the 1" x 6", 2" x 6", and 2" x 2" tiles as pulls and knobs:
Any of the 1x6, 2x6, or 2x2 tiles (4x4 are not available for conversion) can
be made into pulls or a 2x2 square knob. Pricing for each will be identical as shown in the charts on each page for the tiles, with the exception of a set up fee. The set up fee is $85 to convert an order.
Thus if you order 1, 2, or 3 pulls, you will have the $85 fee once. If you order 13, 50, 100 or more, you still have the $85 only once. So it does make a small quantity a little more expensive, but on a
large quantity, the set up fee defrays to a lesser amount per item.
The way the part numbers will work is:
Tiles have part numbers like PHDT-54-(finish choice). The 'T' after PHD denotes a tile.
Tile conversions will have part numbers like this:
PHDT-K-54-(finish code) = the 'K' after the PHDT represents the 2" x 2" knob.
PHDT-P-61-(finish code) = the 'P' after the PHDT represents a pull for either a 1x6 or 2x6 tile.
IT IS VERY IMPORTANT
TO ADD THAT 'K' OR 'P' TO THE PART NUBMER. Part numbers entered just as PHDT-54-AB will be made as a tile, not a knob. So please double check your entries.
On the 1x6 and 2x6 tiles, the hole CTC will be
made as 3" as the default size. If you would like a center to center in the range of 2-1/2" up to 5", you can request it as such. We know 2-3/4" and 3-3/4" (96mm) are very popular choices. You can have that
done. Make sure to request it if you need something other than the default 3" CTC.
As always, if you have any questions, please e-mail us. |
